Hangar and large-span doors in Newark-on-Trent

At a glance

Planning a new hangar or large shed near Newark-on-Trent? We work with your structural engineer and contractor on multi-leaf sliding, vertical-lift fabric or large sectional doors designed around the building.

Town: Newark-on-Trent
Postcode district: NG24
Area: Nottinghamshire
Survey: Free for new installations

What we fit in Newark-on-Trent

Safety systems. Large doors move a lot of mass, so warning and detection devices are built in from the start.
Drives and controls. Powered leaves with controls to suit the site, plus a way to move the door if power is lost.
Multi-leaf sliding. Leaves stacking to one or both sides, or into door pockets, with no headroom needed.
Refurbishment. Older hangar doors renewed with new wheels, guides, drives and cladding.
Designed per opening. Each door engineered around the opening size, structure and site wind exposure.

What this work can involve

Adding warning beacons, sounders and photocells to an older powered large-span door as part of a site risk assessment review.
Surveying and specifying a very wide sliding or folding door for a building that houses large plant and machinery.
Designing multi-leaf sliding doors, with a tail-fin cut-out where needed, for a hangar or large-span maintenance building.

Who is responsible for door safety at a site in Newark-on-Trent?

In England, two sets of duties meet at a powered door. The installer who supplies or motorises it must hand over a door that meets the Supply of Machinery (Safety) Regulations 2008, tested against BS EN 12453 and documented. The business in control of the premises must then maintain it: regulation 5 of the Workplace Regulations 1992 covers maintenance, and regulation 18 requires upward-opening doors to have a device that stops them falling back and powered doors to have features that prevent trapping.

Access, phasing and timing

Sites in and around Newark-on-Trent vary from tight trade counters to large distribution yards. The survey records access for our vehicle and platform, overhead obstructions and floor condition so the installation day runs without surprises.

Guide prices for hangar and large-span doors

Hangar and large-span doors guide prices
Item	Guide price (ex VAT)
Hangar and large-span doors	on survey (typically from £39,995)

Guide prices for supply and installation unless stated, excluding VAT, which is added at the current rate where it applies. Your fixed price is confirmed in writing after a survey, before any work starts.

Questions from businesses in Newark-on-Trent

Do you service large doors across Nottinghamshire?

Yes. We service and repair hangar and large-span doors across Nottinghamshire, including running gear, drives, controls and safety devices. Service and repair visits are chargeable and quoted before work starts.

Do you work on hangar door projects with our engineer in Newark-on-Trent?

Yes. We coordinate loads, fixings, floor rails and steelwork with your structural engineer and main contractor so the door and the building are designed together, and we agree a programme before manufacture.

How much does a hangar door cost in Newark-on-Trent?

Hangar and large-span doors are priced on survey because each is designed for its opening and structure. Typical projects start from around £39,995 ex VAT. After surveying your site in Newark-on-Trent, we confirm a fixed price in writing.

Hangar and large-span doors near Newark-on-Trent

Newark-on-Trent is in the NG24 postcode district in Nottinghamshire. We also cover Grantham, Arnold, Nottingham.

Other services in Newark-on-Trent

More about Hangar and large-span doors · industrial doors in Newark-on-Trent. Last updated 19 October 2026.