Insulated roller shutter doors in Mold

In short

Replacing a draughty roller shutter in Mold? We remove the old door, fit an insulated curtain with new guides, seals and motor, and hand over a tested, commissioned door with all of its paperwork.

Town: Mold
Postcode district: CH7
Area: Clwyd
Survey: Free for new installations

What we fit in Mold

Colour choice. Powder-coated RAL finishes to match cladding and building trims.
Electric drive. Tubular or external geared motors with a manual override for power cuts.
Controls. From a simple button station to loops and radar, the controls match how often the door opens.
Wind locks. On exposed elevations, wind locks hook the laths into the guides so gusts cannot push the curtain out.
Weather seals. Brush or rubber guide seals and a rubber bottom seal against draughts and rain.

Typical scopes of work

Fitting a compact insulated service door to a plant room to reduce the noise reaching neighbouring offices.
Replacing a corroded single-skin shutter on a heated workshop with an insulated roller door and radio remote control.
Adding wind locks and a heavier geared motor to a wide insulated roller door on an exposed elevation.

Who is responsible for door safety at a site in Mold?

In Wales, two sets of duties meet at a powered door. The installer who supplies or motorises it must hand over a door that meets the Supply of Machinery (Safety) Regulations 2008, tested against BS EN 12453 and documented. The business in control of the premises must then maintain it: regulation 5 of the Workplace Regulations 1992 covers maintenance, and regulation 18 requires upward-opening doors to have a device that stops them falling back and powered doors to have features that prevent trapping.

Access, phasing and timing

Most installations in Mold can be phased so part of the site keeps working. We agree access routes, exclusion zones and any temporary security with you before the team arrives, and can work early mornings, evenings or weekends where the business needs it.

Prices for insulated roller shutter doors in Mold

Insulated roller shutter doors guide prices
Item	Guide price (ex VAT)
Insulated roller door, electric (to c. 4 × 4 m)	£3,195 – £7,495
Strip-out and disposal on replacement	£345 – £1,195 per door

Guide prices for supply and installation unless stated, excluding VAT, which is added at the current rate where it applies. Your fixed price is confirmed in writing after a survey, before any work starts.

Insulated roller shutter doors in Mold: your questions

Can you replace our old roller shutter in Mold with an insulated one?

Yes. We recommend a complete new door rather than a new curtain on old parts, and include strip-out and disposal in the quote so the old shutter goes when the new one is fitted.

Is there enough headroom for an insulated roller door at our Mold unit?

The coil on an insulated curtain is larger than on a single-skin shutter, so we measure the space above the lintel on survey. Where headroom is very tight, the coil can sometimes be fitted outside the opening or a lower-profile option chosen.

Does a powered insulated roller door in Mold need safety devices?

If the door closes automatically or can trap someone, yes. The risk assessment decides what is needed, typically a safety edge, photocells and closing forces tested to BS EN 12453, plus anti-fall protection on heavier curtains.

Insulated roller shutter doors near Mold

Besides Mold, we can survey and quote for sites in Buckley, Connah's Quay, Flint and the rest of Clwyd.

Other services in Mold

More about Insulated roller shutter doors · industrial doors in Mold. Last updated 19 October 2026.